Click for Instructions of Use   >>

​​​IMPORTANT: After soaking a carpet with Odormute solution, the area must be thoroughly dried! Failure to do so may produce a mildew or ammonia odor. If this occurs, you may retreat the carpet with Odormute solution, adding 4 tablespoons of Baking Soda to the machine. The baking soda neutralizes the urine acid and has natural deodorizing properties. 

Small areas may be dried with a hair dryer or electric fan. In larger areas, the carpet and pad should be lifted and thoroughly dried. Special care should be taken with shag or heavy carpets with porous pads. 


Odormute is not recommended for Oriental Rugs.

Carpets and rugs
Always perform test on small area! 

The material and quality of carpets and pads vary greatly. Always test a small, hidden area before treating the total carpet. 
​Hueter Toledo, Inc. will not be responsible for more than the replacement cost of the Odormuteproduct.


Spots and Small Areas 
​1.
Test a small area before use. Soak and let dry. 
​2. In large carpeted areas, all odor sources must be located and treated.  
​3. Dissolve 1 tablespoon in 1 quart of warm water. (Increasing the amount of Odormute will speed the action with no harm to people, pets or fabric). 
4. Soak the carpet and pad in the spots in need of treatment. 
​5. Allow to soak for 1 hour. 
6. Remove excess moisture and allow the carpet to dry. Failure to do so may produce mildew or ammonia odors. Suggestion: you may use towels, a hair dryer or fan to speed drying.


Entire Carpets

1. Test a small area before use. Soak and let dry.
​2. You may use a carpet cleaning machine. Substitute Odormute solution for the carpet cleaning chemicals.
3. Use a ratio of 1 tablespoon Odormute to 1 gallon of warm water. Mix the amount of Odormute needed with 1 pint of warm water until completely dissolved (about 5-10 minutes). Add the solution to the carpet cleaning machine.
4. After the carpet has dried and the odor has been eliminated, you may shampoo the carpet as usual.